Extreme Networks AP-7562 - Page 18

Introduction
AP-7562 Installation Guide
16
installation in commercial and public safety vehicles for mobile deployments. Extreme
recommends using the vehicle mount kit (KT-158767-01) for mobile deployments.
To install the Access Point VMM:
1 Remove the rubber plugs from the four screw holes on the LED side of the AP-7562.
Position unit with screw holes facing upwards.
2 Put the flat plate on top of the VMM. Align the key hole and four screw holes on the flat
plate with the philips screw head and four screw holes on the VMM.