106 Summit 300-48 Switch Software User Guide
Unified Access Security
Displaying Network Login Settings
To display network login settings, use the following command:
show netlogin info {ports <portlist> vlan <name>}
This command displays the netlogin configuration along with wired network login clients. To view the
wireless network login clients, use the following command:
show wireless ports <portlist> interface [1|2] clients
Example
#show netlogin info ports 9 vlan temporary
Port 9: VLAN: temporary
Port State: Not Authenticated
Temp IP: Unknown
DHCP: Not Enabled
User: Unknown MAC: Unknown
In this example, the user is using campus mode and no authentication has taken place. Therefore, the
port state displays as not authenticated. No packets sent by the user on port nine pass the port until
authentication takes place. After authentication has taken place and the permanent IP address is
obtained, the show command displays the port state as authenticated.
#show netlogin info ports 9 vlan corp
Port 9: VLAN: corp
Port State: Authenticated
Temp IP: Unknown
DHCP: Not Enabled
User: auto MAC: 00:10:A4:A9:11:3B
Disabling Network Login
Network login must be disabled on a port before you can delete a VLAN that contains that port. To
disable network login, use the following command:
disable netlogin ports <portlist> vlan <name>
config vlan <name> netlogin-lease-timer
<lease-timer>
Configures the timer value in seconds returned as part of the
DHCP response for clients attached to network enabled ports.
The default value is 10 seconds.
enable netlogin session-refresh <minutes> Changes the refresh rate of the session. Specify the rate in
minutes from 1 to 255. The default is 3 minutes.
enable dhcp ports <portlist> vlan <name> Enables DHCP on a specified port in a VLAN.
enable netlogin ports <portlist> vlan <name> Enables network login on a specified port in a VLAN.
disable dhcp ports <portlist> vlan <name> Disables DHCP on a specified port in a VLAN.
disable netlogin ports <portlist> vlan <name> Disables network login on a specified port in a VLAN.
Table 46: Network Login Configuration Commands (continued)
Command Description
To Next Page
Loading...
