Extreme Networks Summit 300-48 - Summary of Wireless Features; Wireless Devices; Sample Integrated Wired and Wireless Network

76 Summit 300-48 Switch Software User Guide
Wireless Networking
Figure 6: Sample integrated wired and wireless network
This arrangement is part of the Extreme Unified Access Architecture, which is designed to support both
wired and wireless networks from a single network switch. Because the intelligence normally associated
with an access point is maintained in the Summit 300-48 switch, the cost of implementing radio access is
greatly reduced. The network can still be expanded as needed, but it becomes much easier to maintain
security and reliability at reduced cost.
Summary of Wireless Features
The Summit 300-48 switch supports the following wireless features:
• Simultaneous support for 802.11A, 802.11B, and 802.11G
• EAP authentication for 802.1X devices—PEAP, EAP-TLS, and EAP-TTLS
• WPA using TKIP and AES
• Detachable Altitude 300-2d antenna
• Integrated Altitude 300-2i antenna
• Per-user VLAN classification
• AccessAdapt™ management
• Remote troubleshooting
• Easy upgrading of wireless ports
• Detailed reports and logging
Wireless Devices
Ports on the Summit 300-48 switch with the “personality” of the device to be connected. Each port
contains separately configurable interfaces for each of its two radios (A and G).
LB48018A
Wired network
Summit 300-48
Altitude 300
Wireless
clients
Wireless
clients
Altitude 300