Per-Port LEDs
Summit 300-48 Switch Software User Guide 139
If there are an excessive number of power supply failures (five or more within a five minute period), a
critical syslog message is issued and the PoE system shuts down until reset by the operator.
The error message is similar to the following:
CRITICAL: Excessive inline-power PSU failures for slot <slot number> - operator
inline-power reset required
Per-Port LEDs
The per-port LEDs indicate link and power status for PoE usage, as indicated in Table 59:
NOTE
Wait for the LED to extinguish before reconnecting to the port.
Configuring Power Over Ethernet
Use the inline power commands in Table 60 to configure PoE on Summit 300-48 switch ports.
NOTE
Configuration parameters affecting operational parameters require the port or slot to be first disabled.
reset inline-power slot <slot number> Use this command to reset the Poe system for a specific slot.
Table 59: Per-Port LEDs
Port Disabled Link Up Link Down Activity
Non-powered
device
off solid green off blinking green
Device powered blinking amber solid amber amber/green blinking amber
Power Fault amber/green amber/green amber/green amber/green
Table 60: Power Over Ethernet Configuration Commands
Command Description
enable inline-power Enables PoE on the switch. Controls whether inline power will be
provided to the system. Default is enable.
disable inline-power Disables PoE on the switch. Setting the value to disable will shutdown
power currently provided on all ports on all slots.
Table 58: Power Supply Mode Commands (continued)
Command Description
To Next Page
Loading...
