Configuring Wireless Ports
Summit 300-48 Switch Software User Guide 89
Configuring Wireless Ports
Table 39 lists the configuration commands for wireless ports.
Table 40 identifies property values for configuring wireless ports.
Configuring Wireless Interfaces
Each wireless port on the Summit 300-48 switch contains two interfaces. Interface 1 supports 802.11A,
and interface 2 supports 802.11G radio signals. The
configure wireless interface commands allow
you to configure one of the two individual interfaces (1|2) on a port or ports. You can move an
Table 39: Wireless Port Configuration Commands
Command Description
config wireless ports <portlist> <property> Configures the named property for the specified
port or ports. See Table
40 for <property> values.
reset wireless ports <portlist> Resets the specified ports.
enable wireless
ports <portlist>
Administratively enables a wireless port for use.disable wireless ports <portlist> Administratively disables a wireless port for use.
enable wireless
ports <portlist>
time <date
> <hour>
Enables the specified ports at the given date (m/d/yyyy) and hour (0-23).
disable wireless ports <portlist> time <date> <hour> Disables the specified ports at the given date
(m/d/yyyy) and hour (0-23).
enable wireless ports <portlist> every <hour> Enables the specified ports every date at the
specified hour.
disable wireless ports <portlist> cancel-scheduler Cancels previously scheduled enable or disable
scheduling commands for the port.
Table 40: Wireless Port Configuration Property Values
Property Default Allowed Values Description
ipaddress 192.168.0.100 + port number (1-48) NA Indicates the source IP address. The
IP address must be an IP address on
the management VLAN.
location “Unknown Location” N/A Identifies the location to be
configured.
health-check on off | on Indicates whether the health check
reset function is on or off. This
determines whether the port should
be reset if the health check timer
expires.
To Next Page
Loading...
