Extreme Networks Summit 300-48 - Configuring Wireless Switch Properties

Configuring Wireless Switch Properties
Summit 300-48 Switch Software User Guide 87
Client Aging
Client aging allows you to configure an aging timer for wireless stations. When a specified period of
time elapses with no data traffic from the client to the Altitude 300, the client is de-authenticated and
removed from all client station tables for that interface. After a client is aged out, it can reassociate and
re-authenticate to the Altitude 300. Age-out information can be collected from such events as client
station failures, station idle-timeouts, or a client abruptly leaving the wireless network without notifying
the associated Altitude 300. To configure client aging parameters, use the command listed in Table 34.
Configuring Wireless Switch Properties
Table 35 lists the wireless configuration command that applies to the switch as a whole. Table 36 lists
the command properties
.
Timeout This is the time, in seconds, that entries will persist in the historical client tables
after the referenced client is removed from the SIB.
CurrentSize The current number of entries in the historical client database
Watermark The maximum number of entries which have ever been in the historical client
database.
Overflows Number of entries which have been overwritten in order to make room for a new
entry.
AgeOuts Number of entries which have been aged out of the table
Table 34: Client Aging Configuration Command
Command Description
configure wireless ports <portlist>
detected-station-timeout
Use this command to configure the time period for the client
connection to age out. The default value is 600 seconds and the
range is 60 to 3600 seconds. This value is configured for each port
and affects both interfaces 1 and 2.
Table 35: Switch-Level Wireless Configuration Commands
Command Description
configure wireless <property> Configures properties that are independent of the port or port interface.
See Table 36 for <property> values.
Table 36: Switch-Level Configuration Property Values
Property Default Allowed Values Description
country-code extreme_default See the following
section
Sets the country identifier for the switch.
default-gateway IP address Indicates the IP address of the default
gateway for the wireless management
VLAN.
management-vlan default Textual value
character string
Identifies the VLAN on which the Altitude
300 communicates with the Summit
300-48 switch.
Table 33: Client Diagnostic and History Information (continued)
Variable Description