Extreme Networks Summit 300-48 - Force Disassociation; Wireless Interface Configuration Commands; Force Disassociation Command

90 Summit 300-48 Switch Software User Guide
Wireless Networking
interface from one profile to another without having to shut it down. Table 41 lists the configuration
commands for wireless ports.
Force Disassociation
Force disassociation permits client user disassociation based on a recurring schedule, a date and time, or
a particular MAC address. You can also disassociate a user immediately. You can specify access based
on a preferred time periods, such as during off-hours, weekends, and holidays. You can also set up a
user policy on a RADIUS server to allow user authentication based on time of day. To configure force
disassociation, use the command listed in Table 42.
Table 41: Wireless interface Configuration Commands
Command Description
config wireless ports <portlist> interface [1 | 2] rf-profile
<name>
Attaches the port in the port list to the named RF
profile. All ports in the port list must have the same
wireless port version.
config wireless ports <portlist> interface [1 | 2]
security-profile <name>
Attaches the ports in the port list to the named
security profile. All ports in the port list must have
the same wireless port version.
config wireless ports <portlist> interface [1 | 2] channel Configures a channel for the specified interface.
Default is Auto for both interfaces.
config wireless ports <portlist> interface [1 | 2]
power-level
Configures the power level for the specified
interface (full, half, min, one-eighth, quarter).
Default is full.
config wireless ports <portlist> interface [1 | 2]
transmit-rate
Configures a transmission rate for the specified
port. Choice of rates depends upon the mode of the
interface (A or G). Default is 54Mbps.
enable wireless ports <portlist> interface [1 | 2] Enables or disables the specified port interface.
disable wireless ports <portlist> interface [1 | 2] Enables or disables the specified port interface.
reset wireless ports <portlist> interface [1 | 2] Forces the wireless interface to reset.
Table 42: Force Disassociation Command
Command Description
configure wireless ports <portlist>
force-disassociation [all-clients
[every <hour <0-23>> <minute <0-59>>
| time <month <1-12>> <day> <year <yyyy>> <hour
<0-23>> <minute <0-59>>]
| cancel-scheduler
| <mac-address>]
Configures the client force-disassociation capability. All the
times used as parameters in this command refer to
absolute, not relative times.
• all clients specifies all clients associated with the
port list.
• every specifies a repeating disassociation.
• time parameter specifies a single disassociation at a
specific time on a specific date. If you do not specify the
every or time parameters, the user is immediately
disassociated.
• cancel-scheduler parameter disables forced
disassociation.
• mac-address indicates the MAC address of the client
network interface card.