Extreme Networks Summit 300-48 - Page 141

Configuring Power Over Ethernet
Summit 300-48 Switch Software User Guide 141
config inline-power
violation-precedence [advertised-class |
operator-limit | max-class-operator |
none] ports <portlist>
Sets the violation precedence for the specified ports. A value of
advertised-class will remove/deny power in the case an 802.3af
compliant PD consumes power beyond its advertised class limit. There
are three controls:
• operator-limit—removes/denies power if the PD consumes
power beyond the configured operator-limit.
• max-class-operator—removes/denies power if the PD consumes
power beyond the maximum of the detected class limit and the
operator-limit.
• none—removes/denies power in case the PD device exceeds the
maximum allowable wattage according to regulatory maximum of
20,000 mW. The default is max-class-operator, which allows
operation of 802.3af compliant PDs.
config inline-power reserved-budget
<milliwatts> ports <portlist>
Sets the reserved power on the specified port(s) to either the default
value or the specified watts. Range is 0 or 3000-20000 mW. The default
value is 0 mW. Total power reserved may be up to but not greater than
the total power for the card. If all of the power available to the card is
reserved, then the common power pool is empty.
clear inline-power fault ports <portlist> Clears the fault condition on the specified ports.
reset inline-power ports <portlist> Power cycles the specified ports. Ports are immediately de-powered and
re-powered, maintaining current power allocations.
config inline-power detection [auto |
discovery-test-only] ports <portlist>
Controls the power detection mechanism on the port. Test mode forces
power discovery operations, however power is not supplied to detected
PDs.
unconfig inline-power detection ports
<portlist>
Resets the power detection scheme to the default.
unconfig inline-power operator-limit
ports <portlist>
Resets the operator limit back to the default.
unconfig inline-power
violation-precedence ports <portlist>
Resets the violation precedence back to the default.
unconfig inline-power reserved-budget
ports <portlist>
Resets the reserved budget back to the default (0 milliwatts).
config inline-power priority [low | high |
critical] ports <portlist>
Configures the port priority. Power allocation is provided first to higher
priority ports. The default value is low.
unconfig inline-power priority ports
<portlist>
Resets the port priority to the default (low).
clear inline-power stats <slot:port> Clears inline power stats on the specified ports.
Table 61: PoE Show Commands
Command Description
show inline-power Displays inline power status information for
the system.
show inline-power configuration port <portlist> Provides inline power information for the
specified port(s).
show inline-power slot <slotlist> Provides inline configuration information
for the specified slot(s).
Table 60: Power Over Ethernet Configuration Commands (continued)
Command Description