Extron electronics DTP CrossPoint 4K Series - Operation

DTP CrossPoint 4K Series • Front Panel Operations 17
Front Panel Operations
This section describes simple DTP CrossPoint matrix switcher
operation from the front panel. Topics that are covered include:
• Creating a Tie
• Recalling a Preset
• Viewing Ties
• Assigning a Logo to an Output
• Viewing and Adjusting Volume and Mic Volume
• Setting the Front Panel Locks (Executive Modes)
Creating a Tie
NOTES:
• "Tie" is an input-to-output connection.
• "Set of ties" is an input tied to two or more outputs. (An
output can never be tied to more than one input.)
• "Conguration" is one or more ties, one or more sets of ties,
or a combination.
1. Press and release the Esc button to clear any input button,
output button, or control button indicators that may be lit.
2. Press and release the Video and Audio I/O buttons to select or
deselect video, audio, or both as desired.
I / O
VIDEO AUDIO
Green
when selected
Off when deselected
Red when selected
Off
when deselected
NOTE: Audio or video can be broken away (tied by itself)
by selecting only the Video button or only the Audio
button.
3. Press and release the desired input button.
5
The button lights to indicate the selection.