Extron electronics DTP CrossPoint 4K Series - Starting the DSP Conigurator Program

31DTP CrossPoint 4K Series • Remote Control
Starting the DSP Configurator Program
The DSP Congurator can connect to the switcher via any rear
panel LAN port or the front panel Conguration port.
NOTE: Extron recommends connection via an Ethernet LAN
port for the DSP Configurator program.
Start the DSP Congurator program, as follows:
1. Click Start > Programs > Extron Electronics > DSP
Configurator > DSP Configurator. The DSP Congurator
Startup screen opens (see gure 24).
Figure 24. DSP Configurator Screen and Device Selection
TIP: You can also launch the DSP Configurator program
from within the Product Configuration Software.
2. Select the DTP CrossPoint switcher in the drop-down menu
and click OK.
TIP: If you have only DTP CrossPoint switchers of the
same model, click Always perform the selected action
to eliminate step 2 in future startups.
The DSP Congurator program starts in Emulate mode (see
figure 25 on the next page).
NOTE: In Emulate mode, changes and settings are stored
in the PC and not sent to the switcher until you select Live
mode and "push" the settings to the switcher. See the
DTP CrossPoint 4K Series User Guide.