Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
OPERATING PROCEDURES
Owner’s Guide
51
Before a new vehicle is put into operation, the items shown in the INITIAL SERVICE CHART must be
done.
Brake Burnishing Procedure
For new vehicles or after replacement of brake pads or rotors, it is recommended that approximately 20 stops
with moderate braking from 20 mph to 5 mph should be made without coming to a complete stop. This proce-
dure will assure that your new brakes will function to their full potential and maintain maximum wear resis-
tance.
Determine and record the braking distance required to stop the vehicle for future brake performance tests.
INITIAL SERVICE CHART
Item Service Operation
Batteries Charge batteries
Seats Remove protective plastic covering
Brakes Check master cylinder fluid level & brake operation
Perform brake burnishing procedure
Establish acceptable stopping distance
Tires Check air pressure (see SPECIFICATIONS)
To Next Page
Loading...
