Owner’s Guide
66
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
OPERATING PROCEDURES
Starting and Driving
All vehicles have an interlock system that disables the controller and prevents operation of the vehicle while
the charger is connected. Remove the charger plug from the receptacle and correctly store the cable before
you move the vehicle.
To operate the vehicle:
• Apply the brake, put the key in the key switch and turn the direction selector to the correct direction.
• Slowly press the accelerator pedal to start the motor and release the brake pedal.
• When the accelerator pedal is released, the motor decreases the speed of the vehicle. To stop the
vehicle quickly, press the brake pedal.
When the direction selector is in the reverse position, a warning signal activates to indicate that the
vehicle is ready to run in the reverse.
Starting Vehicle On A Hill
The parking brake will activate automatically when the vehicle comes to a stop. To start the vehicle on a hill,
press the accelerator pedal and the parking brake will be released.