Owner’s Guide
54
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
OPERATING PROCEDURES
ON-BOARD CHARGER WITH DC TO DC CONVERTER
Risk of electric shock. Connect the charger power cord to an outlet that is cor-
rectly installed and connected to an electrical ground according to all codes and
regulations. A grounded outlet is necessary to decrease the risk of electric shock
– do not use ground adapters or replace the plug. Do not touch parts of output
connector or battery terminals that do not have insulation.
Disconnect the DC plug before you make or break the connections to a battery
that is charging. Do not open or disassemble the charger. Do not operate the char-
ger if the AC cord is damaged. Make sure qualified personnel do all repair work to
the charger.
To Next Page
Loading...
