Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
OPERATING PROCEDURES
Owner’s Guide
53
To keep seat belts in correct, working condition, do the following:
• Inspect the seat belt webbing and hardware periodically. Check for cuts, worn or loose parts. Replace
the components if wear or damage is seen.
• Keep seat belts clean and dry. To clean, use mild soap and warm water. Do not use bleach, dye or abra-
sive cleaners as this will weaken the belt webbing material.
• Do not put any objects into the retractor mechanism.
• Periodically check for normal operation. Replace the mechanism if it is not operating correctly.
To secure the seat belts:
1. Pull the metal tab on the seat belt across the body toward the correct buckle found near the center of the
seat.
2. Insert the tab into buckle. (A click will be heard when the tab is securely latched).
3. Position the lap belt as low as possible on the hips, not at the waist.
Adjust to make sure of a tight fit by pulling the shoulder portion upward.
The retractor will lock the belt during sudden stops. It can lock if a person bends forward quickly. Slow, easy
motions allow the belt to travel freely. To release the safety belt, press the buckle release button and allow
the belt to retract. If the belt does not retract, check for twisted straps.
To Next Page
Loading...
