Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
OPERATING PROCEDURES
Owner’s Guide
63
Pedal-Up Braking
Pedal-up braking is regenerative braking that occurs when the accelerator pedal is released while the vehicle
is moving.
Example: If both of the following events occur:
a. The vehicle is being driven down a slope
b. The accelerator pedal is released
The pedal-up braking will slow the vehicle until the vehicle stops, or the accelerator pedal is applied. When
pedal-up braking system is activated by this sequence of events, the motor generates power that is returned
to the batteries.
High Pedal Disable Feature
High pedal disable prevents acceleration if the key is turned on while the accelerator or brake are pressed.
To reset the controller after a High Pedal Disable, place both feet on the floor, turn the key to the OFF
position. With both feet on the floor turn the key to the desired direction and press the accelerator.
Parking Brake
In the event that the vehicle will not move in forward or reverse, the automatic parking brake can be released
using the instructions located on the controller splash shield beneath the seat on the passenger side of the
vehicle. Refer to the Maintenance Procedures section of this manual for in-depth instructions.
To Next Page
Loading...
Need help?
General
