F5 i2800 - Page 19

View valid media types for an interface
Y
ou can use tmsh to view the valid media types for an interface.
Note: This platform might not support all of the media type options that are available in tmsh.
1. Open the TMOS Shell (tmsh).
tmsh
2. Change to the network module.
net
The system prompt updates with the module name: user@bigip01(Active)(/Common)
(tmos.net)# user@bigiq01(Active)(/Common)(tmos.net)#
3. Display the valid media types for a specific interface.
list interface <interface_key> media-capabilities
Important: In all Gigabit Ethernet modes, the only valid duplex mode is full duplex.
This is an example of the output that you might see when you run this command on a specific
interface:
net interface 2.0 {
media-capabilities-sfp {
none
auto
1000SX-FD
1000LX-FD
1000CX-FD
1000T-FD
10000SR-FD
10000LR-FD
10000ER-FD
}
}
V
alid media types
This table lists the valid media types for the tmsh interface command.
Note: This platform might not support all of the media type options that are available in the TMOS Shell
(tmsh).
10baseT half 1000baseLX full
10baseT full 1000baseCX full
10GbaseER full 1000baseT half
10GbaseLR full 1000baseT full
10GbaseSR full 1000baseSX full
10GbaseT full 100GbaseSR4 full
10SFP+Cu full 100GbaseLR4 full
40GbaseSR4 full auto
40GbaseLR4 full none
100baseTX half no-phy
Platform Guide: i2000/i4000 Series
19