F5 i2800 - Power specifications - i4000 (i4600;i4800) Series; Safety requirements; EMC requirements

Item Single power supply Dual power supply
Idle power draw (AC power) 110VAC input: 95W
220V
AC input: 90W
110VAC input: 95W
220VAC input: 95W
Typical power draw (AC power; 50% load;
temp 25°C)
110VAC input: 130W
220VAC input: 125W
110VAC input: 130W
220VAC input: 130W
Typical power draw (DC power; 50% load;
temp 25°C)
48VDC input: 135W 48VDC input: 145W
Maximum power draw (AC power) 110VAC input: 165W
220VAC input: 160W
110VAC input: 160W
220VAC input: 160W
Maximum power draw (DC power) 48VDC input: 165W 48VDC input: 180W
Typical heat generated (AC power) 110VAC input: 445 BTU/
hour
220VAC input: 430 BTU/
hour
110VAC input: 445 BTU/
hour
220VAC input: 445 BTU/
hour
Typical heat generated (DC power) 48VDC input: 465 BTU/
hour
48VDC input: 495W
Maximum heat generated (AC power) 565 BTU/hour 550 BTU/hour
Maximum heat generated (DC power) 565 BTU/hour 615 BTU/hour
Important: Specifications ar
e subject to change without notification.
Safety requirements
This equipment complies with these requirements of the Low Voltage Directive 2014/35/EU:
EC Type Examination Certificates: Master Contract 252302
CB Scheme
EN 60950-1:2006+A11:2009+A1:2010+A12:2011+A2:2013
IEC 60950-1:2005, A1:2009+A2:2013
CSA 60950-1-07, Including A1:2011+A2:2014
ANSI/UL 60950-1-2014
EMC requirements
USA--FCC Class A, Canada--Industry Canada Class A
This equipment complies with Part 15 of FCC Rules. Operation is subject to these two conditions:
1. This equipment may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
operation.
Eur
opean Union
This equipment complies with these requirements of the EMC Directive 2014/30/EU:
Platform Specifications
50