Disable network configuration
Y
ou can connect to the system's serial console to disable SSH access to AOM over the network. This
does not affect console access to AOM.
1. Connect to the system using the serial console.
2. Open the AOM Command Menu.
Esc (
3. Type n to open the AOM management network configurator.
4. When prompted about using DHCP, type n.
5. At the IP address prompt type 0.0.0.0.
A confirmation message displays the configured management IP address, netmask, and gateway.
6. (Optional) Type i to verify that network configuration is disabled.
Platform Guide: i2000/i4000 Series
23
To Next Page
Loading...
