10
7 POSITIVE STOP ACCESSORY
In case the gate doesn’t have built in mechanical stops, it
is possible to install, directly on the operator, an accessory
to limit the rod’s travel in both directions.
(P/N: 490109 STANDARD, 490043 EG)
The accessory is mounted on the front flange of the
operator using the supplied bolts.
With the use of the proper square shaped swivel joint (sup-
plied):
It’s possible to limit the rod’s travel and create two solid
mechanical stop positions.
NOTE: The positive stops has 4 rods, 2 are shown for illustra-
tion purpose only.
For additional details please refer to the instructions included
with the positive stop accessory.
To Next Page
Loading...
