FAAC 844 - 844 Technical Data

4
844 Technical Data
Physical dimensions of the operator case Length: 9 3/4 in. (24.7 cm)
Width: 8 1/2 in. (21.5 cm)
Height: 15 1/4 in. (38.6 cm)
Power voltage required
1
230 VAC, +6 or - 10%, 60 Hz
Absorbed power 650 Watts
Amperage draw 2.5 amps
Horsepower rating 3/4 hp
Speed of motor rotation 1400 rpm
Gear ratio 30:1
Operating temperature range -4 to +131 deg F
(-20 to +55 deg C)
Weight, including oil 33 lb (15 kg)
Oil quantity 2-1/8 qt (2 liters)
Oil type FAAC XD 220 or
Shell/Tellus #15
Gate speed
Z20
Z16
10 in./sec (25 cm/sec)
8 in./sec (20 cm/sec)
Pulling force
2
at start up under maximum load
Z20
Z16
100 lb (45 kg)
125 lb (57 kg)
Duty cycle, % motor run time at 72°F (24°C)
50
1
Your standard 220 VAC power source meets the specification for 230 VAC, +6 or -10%.
2
The maximum pulling force at start up assumes nominal voltage (220 VAC) at 72 deg F (24
deg C) and assumes the use of high-quality, lubricated bearing rollers on a level V track.
Control Panels
You may install either of the following control panels
with the 844 Operator. Both the control panel and the
operator require the same power supply voltage, 220
VAC.
Note: Your standard 220 VAC power source
meets the specification of 230 VAC, +6
or -10%.
844 B/C
Logics available: B, C, B/C, and C/B
(see page 6)
Maximum motor run time: 240 sec
844 MPS
Logics available: E1, A1, S1, and S2
(see pages 7−8)
Maximum motor run time: 120 sec
Upswung.com