28
ENGLISH ENGLISH
MANUAL
TWO-WAY
ONE WAY
PARTIAL OPENING
TOTAL OPENING
AUTOMATIC
DOOR OPEN
NIGHT
쐃
쐇
쐋
쐏
쐄
OPERAOPERA
OPERAOPERA
OPERA
TING FUNCTIONSTING FUNCTIONS
TING FUNCTIONSTING FUNCTIONS
TING FUNCTIONS
Selection is performed by pressing the keys on the fixed
part of the programmer - the function is indicated by the
relevant LED lighting up.
Note: when the “Night” or “Manual” modes have been
set, the relevant selection keys must be pressed to exit the
modes.
MANUALMANUAL
MANUALMANUAL
MANUAL
The sliding leaves are free and can be activated manually.
TWOTWO
TWOTWO
TWO
--
--
-
WW
WW
W
AA
AA
A
YY
YY
Y
Pedestrian transit is possible in both directions; the inside
and outside radars are enabled.
ONE WONE W
ONE WONE W
ONE W
AA
AA
A
YY
YY
Y
Pedestrian transit is possible in one direction only; the
external radar is disabled.
PP
PP
P
ARTIAL OPENINGARTIAL OPENING
ARTIAL OPENINGARTIAL OPENING
ARTIAL OPENING
The door opens only partially (standard: 50%)
Partial opening can be adjusted in range from 10% to 90%
of total.
TOTTOT
TOTTOT
TOT
AL OPENINGAL OPENING
AL OPENINGAL OPENING
AL OPENING
The door opens completely.
AA
AA
A
UTOMAUTOMA
UTOMAUTOMA
UTOMA
TICTIC
TICTIC
TIC
The door opens (partially or totally) and then re-closes after
the set pause time (standard: 2 sec.).
Adjusting range of pause time: 0 to 90 sec.
DOOR OPENDOOR OPEN
DOOR OPENDOOR OPEN
DOOR OPEN
The door opens and stays open.
NIGHTNIGHT
NIGHTNIGHT
NIGHT
The door closes and the lock (if present) is activated. The
internal and external radars are disabled.
The Key command causes the door to open and re-close
after night pause time elapses (standard: 8 sec).
Adjusting range of night pause time : 0 to 240 sec.
To obtain partial opening in this mode, before selecting
the “Night” function, activate the “Partial Opening”
function .
SPECIAL FUNCTIONSSPECIAL FUNCTIONS
SPECIAL FUNCTIONSSPECIAL FUNCTIONS
SPECIAL FUNCTIONS
SETUPSETUP
SETUPSETUP
SETUP
Setup is the door initialisation function during which
parameters are self-learned.
To activate, simultaneously press keys 쐃 and 쐄 for 5 sec.
RESETRESET
RESETRESET
RESET
Reset is the function for restoring normal operating
conditions after some types of alarm have been signalled.
To activate, simultaneously press keys 쐇 and 쐋.
LL
LL
L
OCKOCK
OCKOCK
OCK
When active, the Lock function disables SD-Keeper.
To activate (and de-activate), simultaneously press keys
쐋 and 쐏 for 5 sec.
BABA
BABA
BA
TT
TT
T
TERY INSERTION/CHANGETERY INSERTION/CHANGE
TERY INSERTION/CHANGETERY INSERTION/CHANGE
TERY INSERTION/CHANGE
To keep the clock inside SD-Keeper active even in the
event of a power cut, a 3V model CR1216 lithium battery
is provided.
To insert or change the battery, find the compartment on
the printed circuit (fig. 7) and observe the indicated polarity.
fig. 6
쐃
쐇
쐋
쐏
쐄
OK
fig. 7
To Next Page
Loading...
