How to fix FAAC 950 BM if door will not reach it’s full closed position?
If the door of your FAAC Door Opening System does not fully close, check the stop position against the closed position of the door. Additionally, try reducing the spring tension.
What to do if FAAC 950 BM operator will not run the setup cycle?
If the FAAC Door Opening System operator doesn't run the setup cycle, first check that LEDs 5, 6, and 7 are ON, as these indicate safety and stop circuits. Also, make sure you hold down the setup button for at least 5 seconds.
What to do if the FAAC 950 BM door will not automatically close?
If your FAAC Door Opening System's door isn't closing automatically, verify that LEDs 2, 3, 4, and 8 are OFF. These LEDs indicate activation inputs. If any of these LEDs are ON, inspect the corresponding input and test the devices, or consult the activation device manual. Also, ensure that LEDs 5, 6, and 7 are ON. These LEDs indicate safety and stop circuits.
Why FAAC 950 BM door will not open?
If the door of your FAAC Door Opening System isn't opening, make sure that LEDs 5, 6, and 7 are ON, as they indicate safety and stop circuits. Also, check the activation device to see if the corresponding LED illuminates when activated.
How to make FAAC Door Opening System door easier to open manually?
If the FAAC Door Opening System door is hard to open manually, reduce the spring tension.
General| Brand | FAAC |
|---|---|
| Model | 950 BM |
| Category | Door Opening System |
| Language | English |
To Next Page
