Need help?Do you have a question about the FAAC A1400 AIR RDT and is the answer not in the manual?
General| Brand | FAAC |
|---|---|
| Model | A1400 AIR RDT |
| Category | Door Opening System |
| Language | English |
Covers safety for installers, maintenance technicians, workplace, and operators.
Covers preliminary disassembly and steps for wall mounting the head section.
Details fastening the automation in a self-supporting configuration.
Details the procedure for mounting the drive belt around the motor pulley.
Steps for adjusting belt tension using weights and measurement.
Steps for installing the XB LOCK motor block.
Procedure for adjusting belt fitting and clearance for the XB LOCK motor block.
Details the electronic board E1400 RD, its fuses, buttons, and display.
Covers preliminary checks, power connection, and initial system setup.
Specifies checks after setup and procedures for saving the system configuration.
Step-by-step guides for basic and advanced parameter programming.
Lists and explains basic functions like default configuration, leaf number, partial opening.
Lists and explains advanced functions like safety inputs and exit programming.
Explains configuration for J22 outputs and interpretation of input status.
Explains various operating modes like Automatic, Manual, Night, and Door Open.
Details configuration for various inputs like Always Open, External Open, Exit Only, Automatic Open.
Explains configuration options for J22 outputs (e.g., Gong, Error, Battery).
Details obstacle detection and anti-intrusion/Pull&Go functions.
Explains how Energy Saving reduces opening/closing times and false openings.
Explains implementation of Low Energy mode for restricted kinetic energy and forces.
Lists and explains the different status codes displayed for the automation.
Provides a list of error codes and the necessary intervention steps.
Lists system alerts, AUX errors, and their required interventions.
Provides solutions for common problems and outages not covered by diagnostics.
Covers when setup is needed and how to perform it from the board.
Covers when reset is needed and how to perform it from the board.
Outlines when and how to restore factory default settings.
Guides navigation and selection of operation modes via the SDK EVO menu.
Explains how to access and navigate the SDK EVO function menu.
Guides the adjustment of opening and closing motion parameters.
Details configuration of pause times and night sensor delay.
Explains how to enable or disable the Energy Saving function.
Details automation behavior with emergency battery during power outages.
Explains configuration options for motor block type, function, and monitoring.
Sets the opening percentage for Partial Opening mode.
Initiates the system setup process.
Shows cycle counts and details maintenance deadline settings.
Procedure for setting the current time, date, and daylight saving time.
Guides programming time slots and operating modes for automated operation.
Guides users on navigating the SDK EVO selection menu for operation modes.
Guides users on navigating the LKEVO selection menu for operation modes.
To Next Page
