FAAC A1400 AIR RDT - 11. Belt, Casing, and Accessories Assembly; 11.1 Belt Mounting

A1400 AIR RDT 43 532119 04 - Rev. C
2 3
6
4
Nm
1
3
2
1
2
3
1
2
3
1
3
2
56
4
Translation of the original instructions
ENGLISH
11.1 MOUNT THE BELT
close the leaves at the centre line (closing point in case of single leaf)
Move the leaves by hand and ensure the movement is smooth and
friction-less along the stroke.
!
It is obligatory to use the FAAC belt for A1400 AIR RDT
1. Insert one end of the belt around the pulley of Motor_1. Fasten
the two ends with fittings 56(1) and screws 56(2).
!
The middle slot of the belt fitting must be left empty 56-

.
2. Position the assembled fitting with the belt on the carriage.
Comply with 56 positioning and fasten with screws 56-

.

In case of double leaf, the belt joint must be fastened on the lower
fitting (on the left leaf).
The position of the belt fitting determines the opening direction.
3. Position the belt also on the pulley of the second motor.
11. ASSEMBLE THE BELT, CASING AND ACCESSORIES
RISKS
PERSONAL PROTECTIVE EQUIPMENT
REQUIRED TOOLS
8 6
Do not place your hands between: pulley and belt or between sliding
guide and carriage wheels.
Passage opening
Passage opening
Passage opening
Double leaf
Single leaf - RH opening
Single leaf - LH opening