FAAC A1400 AIR RDT - 11.7 Motor Block XB LOCK Mounting & 11.8 Adjustment; 11.7 Motor Block XB LOCK Mounting; 11.8 Motor Block XB LOCK Adjustment

A1400 AIR RDT 49 532119 04 - Rev. C
B
A
64
1
1
1
2
1
2
3
6
4
Nm

65
Translation of the original instructions
ENGLISH
11.7 MOUNT MOTOR BLOCK XB LOCK
1. Install the motor block by engaging the retainer hook

in the
slot

of the motor block 64.
2. Close the leaves.
3. Manually push lever 65-

towards the motor shaft. Check
correct coupling.
4. Move the motor block lever to check clearance between the mo-
tor shaft and motor block coupling 65-

. Otherwise adjust
as described below. 65-

.
!
To disassemble the motor block:
act carefully on the motor retainer to avoid breaking it, leverage
with a slotted screwdriver between retainer hook and motor block
64-

.
11.8 ADJUST MOTOR BLOCK XB LOCK
1. Loosen the two screws 65-

which connect the belt fitting to
the movement carriage (on both carriages in case of double leaf).
2. Slightly move the belt fitting horizontally until achieving
clearance
clearance
between the coupling of the motor shaft and the motor block
between the coupling of the motor shaft and the motor block
by moving the motor block lever
by moving the motor block lever
6 4
64
-
-


; block the previously
; block the previously
loosened screws.
loosened screws.