FAAC A1400 AIR RDT - Assemble the Components; Mechanical Stops

A1400 AIR RDT 22 532119 04 - Rev. C
3
3
5
2
Nm
2
1
1
6
Translation of the original instructions
ENGLISH
6.2 ASSEMBLE THE COMPONENTS
!
Adhere to the correct positioning set out in the relevant diagram:
106/107/109.
MECHANICAL STOPS
!
SINGLE LEAF: 4 mechanical stops are required. Place them at the two
ends of the profile to begin with.
DOUBLE LEAF: 8 mechanical stops are required. Place 4 of them at the
two ends of the profile and 4 in the middle to begin with.
1. Insert the mechanical stops from the side or front 6-

.
2. Check correct position resting on the profile - 6-

and tem-
porarily fasten each mechanical stop 6-

.

After assembling the leaves, the stops’ positions must be adjusted.


