A1400 AIR RDT 39 532119 04 - Rev. C
1
6
4
Nm
52
1
8
9
Nm
1
6
4
Nm
2
6
51
50
Translation of the original instructions
ENGLISH
9.10 ADJUST LEAVES AND CARRIAGES
Act on the carriages to adjust height and depth of the leaves.
Adjust the counter wheel to prevent the carriage coming off the
sliding guide.
HEIGHT OF THE LEAVES
The carriages allow leaf height to be adjusted by ± 7.5 mm.
1. Partially loosen the two screws 50-
.
2. To lift the leaf turn screw
clockwise. To lower the leaf turn screw
anti-clockwise.
3. Tighten the two screws 50-
.
DEPTH OF THE LEAVES
1. Loosen the 2 screws 51-
.
2. Move the leaf on the two slots at the base of the carriages as
desired.
3. Tighten the 2 screws 51-
.
!
After the adjustments check the vertical and horizontal positions of
the leaf with a spirit level.
COUNTER WHEEL
1. Loosen the screw 52-
.
2. Adjust height by sliding the wheel support in the diagonal slot
52-
.
- The wheel must be drawn close to the top profile 52-
. It
is recommended to place a 0.5 mm shim between wheel and
profile. Remove the shim upon completing adjustment.
3. Tighten the screw 52-
.
!
Manually move the leaves to ensure the counter wheel runs freely
along the entire stroke. Ensure there are no friction points with the
surface of the support profile.
To Next Page
Loading...
