A1400 AIR RDT 54 532119 04 - Rev. C
Translation of the original instructions
ENGLISH
J13 MOTOR BLOCK AND MONITORING OPTIONALS
J13
Connection of motor block with monitoring (OPTIONALS)
J14 EMERGENCY BATTERY
!
Installation of the battery is obligatory since it is an essential safety
component.
IMPORTANT: charge the battery before starting up the system.
In this stage, if the battery is flat operation is prevented: only SETUP
may be performed.
When the battery is flat, only setup may be performed; upon comple-
tion the door remains open and error10 is displayed.
The board maintains battery charge, but does not charge batteries
when flat.
To check charge status see LEDs DL5 and DL6 (52).
J14
Emergency battery connection
J17 USB PORT
J17
Connection of the USB memory device
J18 NOT USED
J21 CONFIGURABLE INPUTS
V
G
I1
I2
G
I3
I4
V
J21
V
+24V
accessories power supply
I4 Input4 configurable (programming)
I3 Input3 configurable (programming)
G GND Accessories power supply negative and Common contacts
I2 Input2 configurable (programming)
I1 Input1 configurable (programming)
G GND Accessories power supply negative and Common contacts
V
+24V
accessories power supply
J22 CONFIGURABLE OUTPUTS
V G 01 02 02
J22
O2 Output2 NC/NO configurable relay output (programming)
O2 Output2 NC/NO configurable relay output (programming)
O1 Output1 configurable (programming)
G GND Accessories power supply negative and Common contacts
V
+24V
accessories power supply
J23 J24 J25 OPTIONAL MODULES
J23
Module connection
G-COM / WI-COM / Net-COM
J24
J25
To Next Page
Loading...
