FAAC A1400 AIR RDT - 15. Diagnostics and Procedures; Automation Statuses Overview

A1400 AIR RDT 73 532119 04 - Rev. C
Translation of the original instructions
ENGLISH
15. DIAGNOSTICS AND PROCEDURES
14 Statuses of the automation
Status of the automation
00
00
CLOSED
01
01
in OPENING
02
02
OPEN
03
03
in PAUSE
04
04
in NIGHT-TIME PAUSE
05
05
in CLOSING
06
06
OPEN in EMERGENCY
07
07
in MANUAL mode
08
08
in NIGHT-TIME mode
09
09
Opening with Auxiliary_motor
10
10
System TEST in progress
11
11
STAND-BY
12
12
Safety TEST in progress
13
13
OPEN in ERROR (Press simultaneously + and - to display the active
ERROR)
(
*
)
L0-L2
L0-L2
PHASES L0, L1, L2 of SETUP in progress (flashing)
(
*
)
Status
13
13 is caused by an error which stops the door in open status and prevents
closure. To restore operation, remove the cause and perform a RESET.
15.1 ACOUSTIC SIGNAL
When the time set for the maintenance to be performed elapses, the
control board beeps at each closure indicating a maintenance request:
3s


The maintenance request is set by default upon reaching the MAX
number of cycles: 1 000 000.
With SDK EVO it is possible to:
- modify the number of cycles for maintenance request
- enter a maintenance request date (optional).
!
The acoustic signal is DISABLED in NIGHT-TIME mode and in case of
BATTERY operation.
15.2 SYSTEM DIAGNOSTICS: ALERTS, ERRORS
The display reads
- automation STATUSES 14.
- ERRORS identified by the RED LED DL4 STEADY on interrupt auto-
mation operation. If several errors are present at the same time,
each error is signalled after resolving the previous one. See 15.
- ALERTS of conditions/phase in progress, identified by the RED
LED DL4 blinking are described in 16.

To check active ERROR/ALERT code, press simultaneously + and
-
0.0
RESET/SETUP
DL2
+
- F
J
13
13
Al
Al + alert code
DL4
o
Er
Er + error code
DL4
+
-