FAAC A1400 AIR RDT - Mount Profiles on the Leaves; Mount the Lower Brush Strip; Glass Leaves; Install Leaves

A1400 AIR RDT 33 532119 04 - Rev. C
1
37
38
Translation of the original instructions
ENGLISH
9.2 MOUNT PROFILES ON THE LEAVES
!
Before installing the leaves, ensure there is no cutting or dragging
hazard.
Check leaf verticality.
Remove any protrusions and/or sharp edges on the frame and leaves.
1. Position and fasten the attachment profile on the top of the leaf
37.
!
Use suitable screws for the weight of the leaf with adequate tighten-
ing torque.
2. Position and fasten the lower guide profile on the bottom of the
leaf 38.
9.3 MOUNT THE LOWER BRUSH STRIP
(OPTIONAL ACCESSORY)
1. Cut the brush strip to the same length as the leaf.
2. Insert the brush strip in the suitable housing of the lower guide
profile 38-

.
GLASS LEAVES

For installation of glass leaves see the dedicated section: § 10 
40.
9.4 INSTALL LEAVES
Install each leaf as described below.
- Adhere to the dimensions set out in diagrams 104 to 108
and :
- 108 - 106 for RIGHT single leaf automations
- 109- 107 for LEFT single leaf automations
- 110 - 109 for DOUBLE leaf automations
For manual lifting, arrange for 1 person every 20 kg to be lifted.
!
Adjust the counter wheel 52 39.

Screws not supplied.