A1400 AIR RDT 81 532119 04 - Rev. C
Translation of the original instructions
ENGLISH
5. In the event LKEVOis connected to a board A1400 AIR RDT in which an
unintended function is programmed, a different function is overridden
as indicated:
- from AUTOMATIC ONLY PARTIAL ENTRY
- from AUTOMATIC ONLY PARTIAL EXIT
switches to PARTIAL TWO-DIRECTION AUTOMATIC
- from AUTOMATIC ONLY TOTAL ENTRY
switches to TOTAL TWO-DIRECTION AUTOMATIC
- from PARTIAL NIGHT-TIME
switches to TOTAL NIGHT-TIME
- PARTIAL MANUAL
switches to TOTAL MANUAL
ERRORS
The ERRORS are displayed with a code of blinking LEDs alternating to the
operating mode in progress.
To see the type of ERRORS 23.
6. Other 2-key combinations may be used for other special functions.
LOCK / UNLOCK
+
5 sec.
RESET
+
WARNINGS
+
continuous
FIRMWARE VERSION
+
continuous
17.3 SPECIAL FUNCTIONS
RESET:
Reset clears errors in the memory.
Activation takes place by pressing simultaneously for 5 sec. keys
and
. The LEDs corresponding to the keys switch on then off.
LOCK/ UNLOCK:
The lock blocks and releases the keys of LKEVO
Activation takes place by pressing simultaneously for 5 sec. keys
and
.
The LOCK/ UNLOCK mode change is displayed by switching on for 300msec
then switching off the LEDs corresponding to keys.
WARNINGS:
The warnings are displayed by pressing and holding the keys
and .
The LEDs corresponding to WARNINGS blink for as long as the keys are held.
To see the type of WARNING see 24.
FIRMWARE VERSION:
the firmware version of board E1400 is displayed by pressing and holding
keys
and .
To see the FIRMWARE version see 25.
To Next Page
Loading...
