FAAC A1400 AIR RDT - Menu 4 Indications (Alerts) (Continued); Menu 5 Cycle Counter Functions; Menu 6 Date;Time Settings; Menu 7 Timer Configuration

A1400 AIR RDT 94 532119 04 - Rev. C
Translation of the original instructions
ENGLISH
- 63 Intrusion in progress
- 64 Last opening too slow, not compliant with EN16005
- 65 SETUP in progress
- 66 The AUX board is moving the leaves
- 67 Battery saving
- 68 Alarm on Test
- 69 Door open
- 70 Battery charge level
- 80 Programming other than standard
MENU 5 CYCLE COUNTER
OK
OK
OK
OK
5
CYCLES COUNT
CYCLES RESET
MAINTENANCE
CYCLES NUMBER
■
1 Number of cycles
The display shows the number of cycles performed:
- ABSOLUTE counter not resettable
- RELATIVE counter resettable (with CYCLE RESET)
■
2 Maintenance
To set the deadlines for maintenance request:
- DATE (default: disabled) 00/00/00
- minimum number of cycles: 1000; maximum 1000000 (default)

Entering a date is optional.
■
3 RESET CYCLES
It resets RELATIVE cycle counter to zero. This command requires
confirmation

The ABSOLUTE cycle counter cannot be reset to zero.
MENU 6 DATE / TIME
OK
OK
OK
OK
SET TIME
6
DATE/TIME
SET DATE
DAYLIGHT SAV TIME
■
SET TIME
Set time in HH:mm.
■
SET DATE
Set date in dd/mm/yy.
■
EUROPEAN DAYLIGHT SAVING TIME
European daylight saving time is enabled by default.
Available options are:
- Enabled
- Disabled
MENU 7 TIMER
OK
OK
OK
OK
OK
OK
7
OK
OK
OK
TIMER
MON-SUN
JOLLY SLOTS
SUNDAY
JOLLY
TUESDAY./.FRIDAY
MONDAY
TIMER STATE
MON-FRI
When TIMER is on:
- the HOME PAGE displays alert T 93
- the door operating mode is set automatically based on pro-
grammed time SLOT
- the timer must be disabled to manually change the operating
mode activated by it
Programming requires:
- setting time SLOT for each day of the week or by groups of days.
There are up to 6 time SLOT for each day
- assign an operation mode to each time SLOT
- set any JOLLY
■
1 Timer status
Enables/disables timer function:
- ENABLED
- DISABLED (Default)
When the TIMER is disabled programming is stored.
■
2Monday... 8 Sunday
To program days of the week:
1. Select the day.
2. Select the time SLOT.
MONDAY
ESC ↑ ↓ OK
- > SLOT1
- SLOT2
- SLOT3
- SLOT4
3. Assign an operating mode to the time SLOT:
- No Function (0)
- Auto Twodir Total (1)
- Auto Out Total (2)
- Auto Twodir Partial (3)
- Auto Out Partial (4)
- Open Total (5)
- Open Partial (6)