Need help?Do you have a question about the FAAC A100 Compact and is the answer not in the manual?
General| Brand | FAAC |
|---|---|
| Model | A100 Compact |
| Category | Door Opening System |
| Language | English |
Guides on routing electrical cables for accessories and power supply.
Instructions for preparing and securing the support profile to structures.
Details on how to securely fix the support profile onto a wall.
Steps for preparing the automatic door leaves for installation.
Information and installation of the motor locking device for leaf security.
Final checks and procedures before the automated system is put into operation.
Installation guide for the motor lock accessory in kit systems.
Final checks for starting up the assembled kit system.
Wiring diagram and description for the J7 connector.
How to restore the system to normal operating conditions after alarms.
Detailed explanation of each terminal on the control board J7.
Wiring guide for photocells and safety detectors to J7.
Guide to setting DIP switches for system configuration and functions.
Process for initial system start-up and loading standard configurations.
Overview of default operating functions and settings.
Information on adjusting opening and closing speeds of the door.
Parameter for disactivation and pause time setting in automatic mode.
Parameter for setting the night pause time for night operating mode.
Parameter for setting the door closing speed level.
Parameter for setting the door opening speed level.
Parameter for setting protection 1 input configuration (e.g., closing protection).
Parameter for setting the failsafe 1 input configuration (e.g., sensor monitoring).
Parameter for setting protection 2 input configuration (e.g., closing protection).
Parameter for setting the failsafe 2 input configuration (e.g., sensor monitoring).
Door initialisation process where parameters are self-learned.
How to interpret alarms and fault statuses displayed by the SD-Keeper.
To Next Page
