FAAC E045S - Table of Contents

E045S 1 532373 - Rev.A
Translation of the original instructions
ENGLISH
CONTENTS
EU Declaration of conformity ........................... 2
1. INTRODUCTION TO THIS INSTRUCTION MANUAL ..... 2
Meaning of the symbols used ........................... 3
2. SAFETY RECOMMENDATIONS ......................... 4
2.1 Installer safety ....................................... 4
2.2 Storage .............................................. 4
2.3 Waste disposal ....................................... 4
3. E045S ................................................. 5
3.1 Intended use ......................................... 5
3.2 Limitations of use .................................... 5
3.3 Unauthorised use .................................... 5
3.4 Product identification ................................. 5
3.5 Technical specifications ............................... 6
4. INSTALLATION REQUIREMENTS ....................... 7
4.1 Electrical system ..................................... 7
5. INSTALLATION ........................................ 7
5.1 Tools required ........................................ 7
5.2 Components ......................................... 8
5.3 Connections ......................................... 9
Control devices ........................................ 9
BUS 2easy devices ..................................... 9
LED output ............................................ 9
Electric lock ........................................... 10
XF radio module ...................................... 10
Flashing light ......................................... 10
Motors ............................................... 10
Mains power supply ................................... 11
6. START-UP ............................................ 11
6.1 Turn power on to the board .......................... 11
6.2 Programming .......................................12
6.3 Operating logics ..................................... 14
6.4 Setup............................................... 15
6.5 Configuring movements and timing ..................16
6.6 Adjusting the anti-crushing system ...................16
7. PUTTING INTO SERVICE .............................. 17
7.1 Final checks ......................................... 17
7.2 Close the enclosure .................................. 17
7.3 Final operations ..................................... 17
8. ACCESSORIES ......................................... 17
8.1 BUS 2easy devices ...................................17
Connection ........................................... 17
BUS 2easy photocells .................................. 17
BUS 2easy sensitive edges ............................. 18
BUS 2easy encoder .................................... 18
BUS 2easy control devices ............................. 19
BUS 2easy status ...................................... 20
BUS 2easy device registration .......................... 20
Checking the BUS 2easy devices ........................ 20
8.2 XF radio module .....................................21
Radio controls SLH/SLH LR ............................. 21
Radio controls - RC/LC .................................22
Radio controls - DS .................................... 22
Deleting radio controls ................................ 22
9. UPLOAD/DOWNLOAD .................................23
Upload Operations .................................... 23
Download Operations .................................23
10. DIAGNOSTICS ....................................... 24
10.1 Firmware version ...................................24
10.2 Checking the movement ............................ 24
10.3 Automated system status ...........................24
10.4 LEDs check .........................................24
10.5 Errors .............................................25
10.6 Alarms ............................................25
11. MAINTENANCE ...................................... 26
11.1 Scheduled maintenance ............................ 26
TABLES
 1 Technical data E045S.................................6
 2 BASIC programming menu ......................... 12
 3 ADVANCED programming menu .................... 13
 4 SETUP phases ..................................... 16
 5 Assigning an address to the Photocells .............. 18
 6 Addressing Sensitive Edges ......................... 18
 7 Addressing Control Devices ......................... 19
 8 Automated system status .......................... 24
 9 Status of the LEDs ................................. 24
 10 Errors ............................................. 25
 11 Alarms ............................................ 25
 12 Scheduled maintenance ........................... 26