FAAC E124 - System Components; Switching Power Supply

10
RX CL1 TX CL1
RX CL2TX CL2
+
+
+
f
h
f
h
+
J4
RX OP TX OP
+
f
h
+
J4
TX CL
RX OP/CLTX OP/CL
RX OP TX OP
+
+
+
f
h
f
h
J4
+
+
+
f
h
+
+
+
+
TX CL
RX OP
TX OP
f
h
f
h
J4
TX CL
RX OP/CLTX OP/CL
+
+
+
+
f
h
f
h
J4
J4
f
h
f
h
f
h
f
h
f
h
f
h
f
h
f
h
f
h
f
h
ENGLISH
Connection of 2 pairs of photocells
Other safety
devices
Connection of 1 pair of opening photocells
Other safety
devices
Connection of a pair of closing photocells, a pair of
opening photocells and a pair of opening/closing photocells
Connection of a pair of opening
and a pair of closing photocells
Connection of a pair of closing
and a pair of opening/closing photocells
Connection of one closing safety device and
one opening safety device
Connection of no safety device and stop
If you do not use the FAILS-SAFE device, you
must connect the transmitters power feed to
terminals 6 and 8 of J4.
If you use the FAIL-SAFE device, connect the
transmitters power feed to OUT1 after you have
set it appropriately (see 2nd level programming
and fig. 16).
If you use the FAIL-SAFE device, the non-used
safety inputs too must be jumper connected
to the OUT1 negative (see Fig.16).
Fig. 17
Fig. 18
Fig. 21
Fig. 22
Fig. 23
Fig. 19
Fig. 20