FAAC E124 - Safety Recommendations; Installer Safety; Transport and Storage; Product Disposal

4
+
+
DL1
SW7
J12
J4
M1A
J14
J13
J15
J3
J5
J6
J7
J8 J9 J10 J11
J2
J1
M1A
DL20
DL14
DL13
DL18
DL11
DL17
DL10
DL5
DL15
DL8
SW1
DL3
DL7DL6
SW6
SW3
SW4
DL16
DL12
DL19
DL9
SW2
SW5
LCD
DL2
DL4
ENGLISH
2 WARNINGS
Attention: Before attempting any work on the control unit (connections, maintenance), always turn off power.
- Install, upstream of the system, a differential thermal breaker with adequate tripping threshold,
- Connect the earth cable to the relevant terminal (see fig.5).
- Always separate power cables from control and safety cables (push-button, receiver, photocells, etc.). To avoid any
electrical disturbance, use separate sheaths or a screened cable (with the screen earthed).
3 LAYOUT AND COMPONENTS OF E124
3.1 INPUTS DEFAULT SETTING
Terminal-board J4
IN1 OPEN A N.O. contact
IN2 OPEN B N.O. contact
IN3 STOP N.C. contact
IN4 FSW OP N.C. contact
IN5 FSW CL N.C. contact
Connector J13 – XF Module (OMNIDEC)
Channel 1 OPEN A
Channel 2 OPEN B
Connector J14 - Radio
Channel 1 RP OPEN A
Channel 2 RP2 OPEN B
Fig. 7