2
306
64
130
225
a
d
b
c
c
ENGLISH
1 LAY-OUT OF ELECTRICAL BOX
The dimensions of the box are shown in Fig. 1:
Fig. 2 shows the four 5 mm diam.
holes for securing the box (ref.a)
to the wall, the three fittings for
installing the cable grippers M16/
M20/M25 (ref. b) and the two lid
hinges (ref. c).
If it is necessary to remove and
re-position the E124 control board,
make sure that the spacers (ref.d)
are fitted in the supports.
The box contains the E124 control unit and the devices to power it. It must therefore be handled with care during
all installation stages, to avoid damaging its components.
E124 CONTROL UNIT
Dimensions in mm
Fig. 1
Fig. 2
To Next Page
Loading...
