FAAC TM2 X R COMPACT - Second Middle Position; Setting Second Middle Position

Procedure Command sequence
1) Press the A+C buttons
with the motor stopped.
The motor will perform the movement into
position.
Note: in motors with electronic limit switches
the proper positioning is ensured only if the blind
starts from the lower limit position.
SECOND MIDDLE POSITION
This optional function enables the blind to be brought to a second preferred middle
position, which may be used, for example, as a ventilation position. The second
middle position is memorized as ascent time starting from the bottom limit switch.
SETTING SECOND MIDDLE POSITION
Procedure Command sequence
1) Press the B+C buttons for at
least 2 s.
The motor will immediately perform a
brief confirmation movement and after
2 s will start again in descent.
2) Wait for the blind to descend
completely.
The motor is now running in dead man mode,
enabling the fine adjustment of the second
middle position.
3) Con rm the position pressing
B for 2 s.
The motor will perform three (3) confirmation
movements.
MOVEMENT TO THE SECOND MIDDLE POSITION
DELETING THE SECOND MIDDLE POSITION
2 sec
Adjustment
Positioning
2 sec
+ CB
.....
+
B C
B
B
+ CA
+
A C
4 sec
+ CB
.....
+
B C
TM2 X R COMPACT 32 A4518_6H81_Rev.A
EN