FAAC TM2 X R COMPACT - Deleting Limit Switch Positions; Setting Additional Remote Controls; Remote Control Memory Clearing

DELETING THE LIMIT SWITCH POSITIONS
During operation, the control unit automatically acquires the mechanical limit
switch positions set on the motor. In the event that the length or position of the
mechanical limit switches need to be changed, the positions already acquired by
the control unit will need to be deleted.
At the end of the sequence, the control unit is ready to automatically acquire the
new limit switch positions.
ATTENTION! This operation deletes all the memorized middle positions.
SETTING OF ADDITIONAL REMOTE CONTROLS
REMOTE CONTROL MEMORY CLEARING
Up to 15 remote controls can be set.
Tn: Already programmed remote control
Tx: Additional remote control
It is possible to delete singly all the memorized remote controls. When the last
one is deleted the control unit initial condition is restored. The same applies to the
single channels of a multichannel remote control: just select the channel to cancel.
Tn: Remote control to be cleared
4 sec
+ CB + CB + CB
+
B C
+
B C
+
B C
TnTn Tx (2 sec)
+
A
B
+
A B
B
B
TnTn Tn (2 sec)
+
A B
B
A
TM2 X R COMPACT 35 A4518_6H81_Rev.A
EN