UK/IRL
> > > > 49
11 Controlling the appliance
11.1 General
If the main burner or pilot light are extinguished for any reason, do not
attempt to relight the pilot within 5 minutes. Contact a qualified
installer when the appliance goes off regularly.
With control button A you can light the pilot. With the control button B
you can adjust the height of the flames (see figure). All Natural Fire
models feature a remote control which controls the height of the flames.
Knob A
The
is the OFF position preventing any gas from passing through the
control valve. By pressing the knob in it is possible to turn it anti-clock-
wise. The first function is to turn on the gas to the pilot- this occurs just
before reaching the
position (if the fire has not been lit for some time it
may be necessary to hold the knob in this position for some seconds to
clear the air from the pipe and allow gas to reach the pilot burner). Once
gas is available at the pilot, continued rotation anti-clockwise will cause
the piezo igniter to spark. This is accompanied by a click at the valve and
should result in the pilot burner igniting. Once the pilot is lit, the control
knob should be held pressed in for 10 seconds. In this time the pilot flame
will have heated the flame supervision thermocouple sufficiently to
operate a hold-on magnet within the valve. Now turn the control knob A
to the
position. This allows gas to enter control knob B.
fig. 25 Gas control box
To Next Page
Loading...
