UK/IRL
50 < < < <
Knob B
The
is the OFF position preventing gas entering the main burner if the
pilot is lit. The knob should be turned slowly anticlockwise. This allows
gas to enter the burner and be ignited by the pilot flame. Once ignition
has taken place, the fire may be set to any level between min. and max.
by adjusting the control knob B.
11.2 To light
1. Push in and turn the control knob (A) from anticlockwise to the
setting (small flame). You will hear a ignition click. Check that the
pilot is lit (if not, repeat).
2. Continue to hold in the control knob for a further ten seconds to
ensure that the pilot flame is stable.
3. Release the knob. The pilot should remain alight.
4. Turn the control knob A to the
position.
5. Turn knob B slowly anticlockwise, the fire should then ignite.
6. Adjust flames to the required level.
11.3 To extinguish
1. For the main burner turn the control knob B clockwise to position .
2. To disable knob B turn knob A to the
position.
3. To extinguish the pilot turn control knob A to position
, although it
is in order to leave the pilot permanently lit.
11.3.1 When the pilot extinguishes
Warning! When the pilot extinguishes you should wait at least 5 minutes
before trying to turn it on again. Possible causes can be:
- Operating error.
- Interference of the safety device.
- Failure in the pilot flame system.
Contact a qualified installer when the appliance goes off regularly.
To Next Page
Loading...
