All rights reserved. No part of this documentation may be transmitted,
transcribed, stored in a backup device or translated into another
language without Fagor Automation’s consent. Unauthorized copying or
distributing of this software is prohibited.
The information described in this manual may be subject to changes due
to technical modifications. Fagor Automation reserves the right to change
the contents of this manual without prior notice.
All the trade marks appearing in the manual belong to the corresponding
owners. The use of these marks by third parties for their own purpose
could violate the rights of the owners.
It is possible that CNCelite can execute more functions than those described
in its associated documentation; however, Fagor Automation does not
guarantee the validity of those applications. Therefore, except under the
express permission from Fagor Automation, any CNCelite application that is
not described in the documentation must be considered as “impossible”. In
any case, Fagor Automation shall not be held responsible for any personal
injuries or physical damage caused or suffered by the CNCelite if it is used
in any way other than as explained in the related documentation.
The content of this manual and its validity for the product described here has
been verified. Even so, involuntary errors are possible, hence no absolute
match is guaranteed. However, the contents of this document are regularly
checked and updated implementing the necessary corrections in a later
edition. We appreciate your suggestions for improvement.
The examples described in this manual are for learning purposes. Before
using them in industrial applications, they must be properly adapted
making sure that the safety regulations are fully met.
ORIGINAL INSTRUCTIONS
To Next Page
Loading...
