Functional safety
328
9.
FUNCTIONAL SAFETY
Ref.1912
DDS
HARDWARE
· 312 ·
EN ISO 13849
EN ISO 13849-1
Safety of machinery - Safety-related parts of control systems - Part.1:
General principles for design.
EN ISO 13849-2
For validation purposes, the standard EN ISO 13849-2 should be used.
Technical data
The technical data on the drive required for the evaluation of the
SRP/CS of the whole machine according to standard EN ISO 13849 is
provided in
T. H9/1 Calculation data according to EN ISO 13849-1.
Examples
See
9.4 Design requirements
IEC/EN 62061
IEC/EN 62061
Safety of machinery - Functional safety of safety-related electrical,
electronic and programmable electronic control systems.
Use of drives in SRECS
While the AXD/SPD drive is not certified according to standard IEC/EN
62061, it can be used to develop SRECS that comply with it, since the
drive is certified according to IEC 61508 and IEC 61800-5-2.
Technical data
The technical data on the drive required for the evaluation of the SRECS
of the whole machine according to standard IEC/EN 62016 is provided in
T. H9/2 Calculation data according to IEC 61508 and IEC 61800-5-2.
Identification of equipment with TÜV certificate
Models
The ·TÜV SÜD FUNCTIONAL SAFETY CERTIFICATE· list the ·DRIVE
AXD/SPD· models certifies with TÜV FS and TÜV NRTL. This document may
be found at the beginning of this manual.
Units
See section, 12.10 Unit identification.
The equipment certified with ·
TÜV SÜD Functional Safety· should include
the following identification mark in the model version label, the features
label, and the packing label:
TÜV SÜD Functional Safety
To Next Page
Loading...
Need help?
General
