16 16
TUNING OPTIONS
4.7
Lo 010 ... 100 Hi BRF default: 050
Brake Force changes the force needed to reach 100% brake input for load cell
brake pedals and is available when a pedal set featuring a load cell brake is
connected to a wheel base via RJ12 or to a PC via USB. ‘Lo’ requires the least
amount of brake pressure, 100 requires the most amount of brake pressure.
BRF can be accessed via the wheel base Tuning Menu as well when the pedals
are connected via RJ12.
After installing the Fanatec PC Driver (Fanatec Control Panel)
open the Fanatec Control Panel, then navigate to ‘Pedals’ as
shown on the right:
BRF (Brake Force)
Enabling this option combines the
brake and accelerator pedals to
operate on a single axis. 49% to 0%
is operated by the brake pedal and
50% to 100% is operated by the
accelerator pedal.
This allows compatibility with older
games that support only a single axis
for braking and accelerating and is
only accessible when connected to a
Fanatec wheel base.
Combined Pedals
To Next Page
Loading...
Need help?
General
