FANATEC CSL Elite V2 User Manual

19 19
The CSL Elite Pedals V2 must not be modied in any way, other than what is
explicitly described in this manual. Endor
®
AG expressly prohibits analysis and
utilisation of the electronics, hardware, software, and rmware contained in this
device. In case di󰀩culties occur when using your CSL Elite Pedals V2, please
use the following troubleshooting guide. You will nd further details and contact
information on Fanatec.com/support/faq.
If the CSL Elite Pedals V2 is not working properly:
TROUBLESHOOTING
6
Problem description Solution
The PC driver or the wheel base does not
recognise the CSL Elite Pedals V2.
Ensure that you have updated your wheel base
and CSL Elite Pedals V2 rmware to the latest
rmware version contained within the latest PC
driver which can be downloaded from fanatec.
com/driver.
Ensure that you are using the RJ12 cable
included with your CSL Elite Pedals V2 package.
Ensure that the RJ12 cables are plugged in the
correct ports of the CSL Elite Pedals V2 and the
correct port of the wheel base. See section 4.6
‘Connections’
Ensure that the RJ12 and USB cables are
plugged in simultaneously. See section 4.6
‘Connections’
After performing a rmware update of the CSL
Elite Pedals V2, the manually calibrated pedal
positions are reset.
After performing a rmware update of the CSL
Elite Pedals V2, the manually calibrated pedal
positions have to be manually calibrated again.
See section 4.7 ‘Tuning Options’, ‘Manual Mode’

FANATEC CSL Elite V2 Specifications

General

Force Feedback	Yes
Connection	USB
Compatibility	PC
Pedals	Not included
Steering Wheel	Not included
Motor	Brushless
Shifter Ports	Dedicated port
Mounting	Table Clamp
Torque	8 Nm
Rotation Angle	1080 degrees
Power Supply	Included