23 23
FFS
(
FORCE FEEDBACK SCALING
)
FFS range: LIN (Linear) / PEA (Peak) FFS default: PEA
FF Scaling reduces maximum FFB
output by a small amount in order
to guarantee a consistent output
between peaks and holding forces
as well as improved general linearity
between game output and torque
output. LIN activates this setting and
PEA deactivates this setting.
5.6.4
PSU FFS Range Max. Torque
Standard PSU
LIN 4 Nm
PEA 5 Nm
Boost Kit 180 PSU
LIN 6 Nm
PEA 8 Nm
NDP
(
NATURAL DAMPER
)
Standard NDP range: 25 … 100 NDP default: 50
Advanced NDP range: OFF 01 … 100 NDP default: 50
Natural Damper provides additional damping which can be adjusted from
OFF to 100. 100 will have the strongest damping eect which reacts to the
acceleration and angle of your steering. If turned OFF, your steering will
have no additional damping, making it easier to turn the steering wheel.
Natural Damper is useful for controlling the speed of the wheel during
oversteer, and also helps to reduce wheel oscillation. Oscillation is typically
caused by latency in the feedback loop, and is more apparent in racing
games that are not optimised for high-torque motors. The default value of
50 provides a balance between steering responsiveness and oscillation
mitigation.
5.6.5
To Next Page
Loading...
Need help?
General
