Lumina 71 Process overview
15
Status feed place
Readout of the feed place status (value between the brackets):
• FREE: Feed place is free to use.
• BUSY
: Feed place is currently feeding, you have to wait till this feed place is free.
• BLOCK: Feed place may not be used.
And setting to manually set the feed place status:
• FREE: The control computer can run the cycle.
• BLOCKED: The control computer will skip the cycle.
• SKIP
: The control computer will skip the following cycle and then set the status of
this cycle to FREE. The amount intended to be given during this cycle will not be
supplied.
• 1-TIME, 2-TIMES, 3-TIMES: The control computer will run the following cycle to
supply an amount. Then the status of this cycle will be set to BLOCK.
Make amount
Setting of the feed amount that would be transported to the feed place.
5.6 Process
Process overview tab page Process
Feed process Readout of the current feed process status: IS ACTIVE or IS NOT ACTIVE.
Feed process status Readout of the current status of the feed process (BLOCK, FREE and BLOCKED.
EMER.STOP.).
Interrupt the feed process as follows:
Select one of the following options, depending on the feed process status:
End
The active feed process will be stopped as soon as the current process is ready. The
weigher will be emptied and the feed dosed out to the hoppers. The control computer
will then stop the feed process and set the process status to ENDED.
When the current feeding cycle has finished, the control computer will set the process
status to FREE to enable the next feeding cycle to start as normal.
If the time for the current feeding cycle is still not finished, re-start the process using the
option Start.
To Next Page
Loading...
Need help?
General
