Lumina 71 Feed feeding place
20
6.4 Dose %
This tab page shows the dosing percentages per feed place.
Feed feeding place tab page Dose %
FP.
Readout of the name of the feed place.
Dos%
Readout of the dosing percentage for the feed place.
The control computer updates the
data after every day change. This means
that the current situation for the following days is shown every day.
Reduction days - Fixed
Setting to change the dosing percentage to a fixed difference. The difference is valid for
the number of days entered. It will be undone again afterwards.
Reduction days -
Variable
Setting to change the dosing percentage to a variable. The control computer gradually
brings the difference back to 100%. The difference is smaller each day.
If both types of difference are combined, the fixed difference will be applied
first; the difference remains the same for a number of days. The variable
difference will be applied next; the difference will gradually be restored to
100%.
If a dosing percentage is entered without reduction days, the control
computer will not reduce the dosing percentage. The different dose still
applies.
6.5 Section
This tab page shows data of the calculated data per section. The controller adopts the data from the curve day that
is entered in tab page Curve FP.
Feed feeding place tab page Set FP
To Next Page
Loading...
Need help?
General
