F&F LE-03MQ CT - Setup; Setup Entry Methods; Navigation; Number Entry Procedure

LE-03MQ CT - User manual
10
The top row presents the higher values, the bottom row presents the lower values + fractional value.
For example:
Indications: 0027 - top row; 845.3 - bottom row presents the value of 27845.3 kWh.
5. SETUP
5.1. Setup entry methods
Some menu items, such as password and CT, require a four-digit number entry while others, such
as supply system, require selection from a number of menu options. After confirming the settings the
meter confirms the adoption of a new parameter by displaying for a moment the word "good".
5.1.1. Navigation
1. Transition to the next position configuration menu.
2. Press to confirm your selection.
3. Edition of value (change of position number by +/- 1)
4. Having selected an option from the current layer, press to confirm your selection. The SET
5.1.2. Number entry procedure
When setting up the unit, some screens require the entering of a nuber. In particular, on entry
to the setting up section, a password must be entered. Digits are set individually, from left to right.
The procedure is as follows:
indicator will appear.
1. The current digit to be set flashes and is set using the and buttons.
2. Press
to confirm each digit setting. The SET indicator appears the last digit has been set.
to exit the number setting routine. The SET indicator will be 3. After setting the last digit, press
xxremoved.
5. Back to the higher menu level. The SET indicator will disappear and you will be able to use
the buttons, again to select further options.
6. exit the configuration menu to the measurements screen.