Fanimation STAFFORD FP8274 Series - How to Assemble Your Ceiling Fan

7
How to Assemble Your Ceiling Fan
1. Remove the hanger ball portion from the downrod
/hanger ball assembly by loosening the set screw
in the hanger ball until the ball falls freely down the
downrod. Remove the pin from the downrod, then
remove the hanger ball. Retain the pin and hanger
ball for reinstallation in Step 6. (Figure 1)
3. Loosen the two set screws in the downrod support.
Route black, blue, white and safety cable wires
through the downrod. (Figure 3)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.
4. Position downrod support and align the clevis pin
holes in both parts. Install the clevis pin and secure
with the hairpin clip.Tighten the two set screws
and locking nuts in the downrod support. (Figure 4)
Pin
Hanger Ball
Set Screw
Downrod
2. Remove the hairpin clip and clevis pin from the
bottom of downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
Figure 3
Black, Blue, White
and Safety Cable wires
Downrod
Figure 2
Figure 1
Hairpin
Clip
Clevis Pin
Set Screws
and Nuts (2)
Figure 4
Downrod
Clevis Pin
Hairpin Clip
Set Screws and
Locking Nuts (2)
Downrod Support